$5/Month Web Listing Traffic Drive. CashApp: $CashSwip

Title
Hydraulic Adapters Company Introduces The Installation Details Of The Connector
Favorites
Description

Hydraulic Adapters Company introduces how to install the connector:

1. The type, specification and pipe configuration of the expander should be checked before installation, and it must meet the design requirements.

2. Before installation, loosen the pressure plate bolts, pull the product to the installation length, and then tighten it diagonally to make it into a whole with a certain amount of displacement, which is convenient for installation and maintenance, and adjust it according to the site size. When working, the reverse axial thrust can be transmitted to the entire pipeline. For overhead use, corresponding fixing brackets must be installed at both ends.

3. For retractors with inner sleeves, care should be taken to ensure that the direction of the inner sleeve is consistent with the flow direction of the medium. The hinge transfer plane of the hinge type retractor should be consistent with the displacement rotation plane.

4. The auxiliary components used for pre-deformation should be removed after the pipeline is installed.

5. It is strictly forbidden to adjust the installation tolerance of the pipe by deforming the expander, so as not to affect the normal function of the expander, reduce the service life and increase the load of the pipe system, equipment, and supporting components.

6. After the piping system is installed, the yellow auxiliary positioning components and fasteners used for installation and transportation on the wave expander should be removed as soon as possible, and the limit device should be adjusted to the specified position according to the design requirements, so that the piping system is adequate in the environment Compensation ability.

7. All movable components of the expander shall not be stuck by external components or limit its range of movement, and the normal movement of each movable part shall be ensured.

8. During the hydraulic test, the secondary fixed pipe frame with the pipe end of the expander should be reinforced so that the pipe does not move or rotate. Regarding the expander and its connecting pipeline used for gaseous medium, it is necessary to pay attention to whether it is necessary to add a temporary support when filling water. The 96 chloride ion content of the water pressure test water cleaning solution does not exceed 25PPM.

Through the above introduction, Metric Thread Fittings Factory hopes that you can simply refer to the content of this article in future use.


Site Icon
Hydraulic Adapters Company Introduces The Installation Details Of The Connector
Categories
Rate the Link
Page Views
39
Link Clicks
0
Visit with QR Code
Share
Add to your Site
<iframe src="https://bookmess.com/widget/72690" frameborder="0" scrolling="no" width="125" height="125"></iframe>
User ReviewsSubmit Your Review
Based on 0 Votes and 0 Reviews
5 Star
0
4 Star
0
3 Star
0
2 Star
0
1 Star
0
Submit Your Review
We'll never share your email with anyone else.