$5/Month Web Listing Traffic Drive. CashApp: $CashSwip

China Die Casting Supplier Introduces The Requirements Of Aluminum Alloy Die Casting Plating

China Die Casting Supplier introduces four commonly used aluminum alloy die-casting electroplating methods as follows:

1. Phosphating of aluminum: through SEM, XRD, potential-time curve, film weight change and other methods, the effects of accelerators, fluoride, Mn2+, Ni2+, Zn2+, PO4, Fe2+, etc. on aluminum phosphating are detailed the study. The results show that: Guanidine nitrate has the characteristics of good water solubility, low dosage and fast film formation. It is an effective aluminum phosphating accelerator: fluoride can promote film formation, increase film weight, and refine grain; Mn2+, Ni2+ can Obviously refine the crystal grains, make the phosphating film uniform and compact, and improve the appearance of the phosphating film; when the Zn2+ concentration is low, the film cannot be formed, and the film formation is poor. As the Zn2+ concentration increases, the O4 content of the film is increased, making the phosphating film heavy PO4 Increase and increase the content of PO4. The added amount increases the weight of the phosphating film.

2. Alkaline electrolytic polishing process of aluminum liquid: The alkaline polishing liquid system was studied, and the effects of corrosion inhibitors and viscosity modifiers on the polishing effect of aluminum liquid were compared, and the alkaline of zinc-aluminum die castings was successfully obtained. Polishing process system, which has a good polishing effect, and for the first time an additive that can reduce the operating temperature, extend the service life of the polishing liquid, and improve the polishing effect. The test results show that good polishing effect can be obtained by adding appropriate additives to NaOH solution; exploratory experiments also found that: under certain conditions, using glucose NaOH solution for DC constant voltage electrolytic polishing, the reflectivity of the aluminum surface can reach 90 % Above, but there are still unstable factors in its reflectivity, which needs to be further studied. The feasibility of using DC pulse electrolytic polishing technology for alkaline polishing of aluminum is discussed. The results show that: pulse electrolytic polishing technology can achieve the effect of DC constant voltage electrolytic polishing, but its polishing speed is slow;

Through the above introduction, Aluminum Die Casting Factory hopes that you can simply refer to the content of this article in future use.

Site Icon
China Die Casting Supplier Introduces The Requirements Of Aluminum Alloy Die Casting Plating
Rate the Link
Page Views
Link Clicks
Visit with QR Code
Add to your Site
<iframe src="https://bookmess.com/widget/46419" frameborder="0" scrolling="no" width="125" height="125"></iframe>
User ReviewsSubmit Your Review
Based on 0 Votes and 0 Reviews
5 Star
4 Star
3 Star
2 Star
1 Star
Submit Your Review
We'll never share your email with anyone else.